Thinning speedball india ink8/24/2023 Worth a try in lieu of investing in expensive spray equipment. One with the de-natured alcholol wipe rag and one without to see just how much drag I will get. allow it to throughly dry and apply a wiped coat of shellac on two pieces. tomorrow I will set up another test piece with the Ink. I am afraid the alcohol on the wipe rag will blotch the surface when making the passes. when using shellac and hand wiping the procedure is to wet your wipe rag with the solvent for shellac which is of course de-natured alcohol and then wring out excess to reduce drag when you apply the actual shellac. My solution is reduced to simply wiping on the seal coat of de-waxed shellac. they aren't giving it away so a failure would be costly in both shellac and wood with a re-build. to cover and I fear the worst on an even cover using spray cans. The problem I have is I don't have a spray system so I would have to wipe the shellac. I totally agree that a "sprayed" seal coat of de-waxed clear shellac would be the best approach to seal off the ink and avoid any wipe off with a wipe finish. And I found that the hint of amber from the oil based did not effect the very dark black as the black ink highly over-powers the amber tone.īut. The India Ink does a through job of spreading and adhering to both maple and poplar for the most part. I also wiped some oil based poly on and got a slight hint of ink but not enough IMO to be a pest wiping with oil poly. It did not pull all the ink off but the wipe pad did have traces on it even though I used the same light stroke I would with poly. I did a simple test dragging a wiping rag with distilled water over the dried India Ink earlier tonight.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |